Buell 2009 XB Series, Руководство по обслуживанию

Страница: 570 / 712

A.4 DEUTSCH ELECTRICAL CONNECTORS
DEUTSCH CONNECTOR REPAIR
TOOL NAME PART NUMBER
DEUTSCH CONNECTOR SERVICE
KIT HD-41475
FLAT BLADE L-HOOK HD-41475-100
General
Deutsch connectors are colored coded for location purposes.
Those connectors associated with left side accessories, such
as the front and rear left turn signals, are gray. All other con-
nectors, including those associated with right side accessories,
are black.
NOTE
A DEUTSCH CONNECTOR SERVICE KIT (Part No. HD-
41475) contains a selection of wire seals, internal seals, seal
plugs, secondary locking wedges, attachment clips and
socket/pin terminals. Also included is a compartmented storage
box, carrying case and a FLAT BLADE L-HOOK (Part No. HD-
41475-100) is used for the removal of all types of locking
wedges.
Separating Pin and Socket Housings
See Figure A-12 . To separate the connector halves, depress
the external latch(es) (1) on the socket housing (2) while
rocking the pin (3) and socket housings.
NOTES
• Generally, the socket housing is found on the accessory
side, while the pin housing is plumbed to the wiring har-
ness.
• Two-, three-, four- and six-place Deutsch connectors have
one latch on the connector.
• Eight- and twelve-place connectors have a latch on each
side. Simultaneously press both latches to separate the
connector.
Mating Pin and Socket Housings
1. Align the connectors to match the wire lead colors.
a. For One External Latch: Two-, three-, four- and six-
place Deutsch connectors have one external latch on
the socket half of the connector. To fit the halves of
the connector together, the latch on the socket side
must be aligned with the latch cover on the pin side.
b. For Two External Latches: (8-place and 12-place)
Align the tabs on the socket housing with the grooves
on the pin housing.
2. Insert socket housing into pin housing until it snaps or
clicks into place.
For Two External Latches: (8-place and 12-place) If
latches do not click (latch), press on one side of the con-
nector until that latch engages, then press on the opposite
side to engage the other latch.
3. If necessary, fit the attachment clip to the pin housing.
4. Place large end of slot on attachment clip over T-stud on
frame. Push assembly forward to engage small end of
slot.
2
3
1
1
sm00017
1. External latch
2. Socket housing
3. Pin housing
Figure A-12. Deutsch Connector
Removing Socket Terminals
1. See Figure A-13 . Insert a small screwdriver between the
socket housing and locking wedge in-line with the groove
(in-line with the pin holes if the groove is absent). Turn the
screwdriver 90 degrees to pop the wedge up and remove
the secondary locking wedge.
2. See Figure A-16 . Use a pick or small screwdriver to
depress terminal latches inside socket housing and back
out sockets through holes in rear wire seal.
NOTE
If wire leads require new terminals, see the instructions for
crimping terminals.
Installing Socket Terminals
1. Match wire lead color to connector cavity.
2. See Figure A-15 . Fit rear wire seal (1) into back of socket
housing (2), if removed.
3. Grasp wire lead (3) approximately 1.0 in. (25.4 mm) behind
the socket terminal. Gently push socket through hole in
wire seal into its chambers until it "clicks" in place.
4. A tug on the wire will confirm that it is properly locked in
place.
HOME
A-8 2009 XB Service: Appendix A Connector Repair