Buell 2009 XB Series, Руководство по обслуживанию

Страница: 395 / 712

2. Place rear shock reservoir assembly (3) into position.
NOTE
See Figure 4-55 . To verify proper reservoir mounting, tempor-
arily place upper body work onto tail section and adjust reser-
voir placement so adjuster screw (1) aligns with alignment hole
(2).
3. See Figure 4-54 . Install reservoir mounting fasteners (2).
Tighten fasteners to 120-144 in-lbs (13.6-16.3 Nm).
NOTES
• Always make sure fuel hoses are seated against the
component they connect to and that hose clamps are
properly tightened and positioned on straight section of
fitting and not on the fitting barb.
• The barb is the larger outside diameter portion (bump) on
the fuel fitting.
4. See Figure 4-54 . Connect two hoses to the canister. Make
sure to push hoses all the way on to carbon canister fit-
tings.
5. Install upper tail body work. See 2.39 SUBFRAME TAIL
ASSEMBLY AND BODY WORK: FIREBOLT .
3
1
2
4
sm00904
1. Mounting plate
2. Rear shock reservoir fasteners (2)
3. Rear shock reservoir
4. Battery
Figure 4-54. Carbon Canister Mounting
1
2
sm00905
1. Adjuster screw
2. Adjuster screw alignment hole
Figure 4-55. Adjuster Screw Alignment
INSTALLATION: LIGHTNING/ULYSSES
Vent Valve
Keep vent and vapor valve lines away from exhaust and
engine. Gasoline is extremely flammable and highly
explosive, which could result in death or serious injury.
(00263a)
NOTE
For XB12 models, See 6.17 INTERACTIVE EXHAUST
SYSTEM .
1. Install vent valve. See 4.12 FUEL TANK VENT VALVE .
2. See Figure 4-54 . Attach fuel tank vent hose (2) to canister
if disconnected.
Canister
NOTE
In next step, be sure canister hose barbs are facing rear of
vehicle at approximately the 1 o'clock position.
1. See Figure 4-58 . Slide canister into position on canister
mounting plate and push towards front of vehicle.
NOTES
• Always make sure fuel hoses are seated against the
component they connect to and that hose clamps are
properly tightened and positioned on straight section of
fitting and not on the fitting barb.
• The barb is the larger outside diameter portion (bump) on
the fuel fitting.
2. See Figure 4-54 . Connect two hoses to the canister. Make
sure to push hoses all the way on to carbon canister fit-
tings.
HOME
2009 XB Service: Fuel System 4-43