Buell 2009 XB Series, Руководство по обслуживанию

Страница: 413 / 712

6. Place pressure plate, diaphragm spring, adjusting screw
assembly with new retaining ring and spring seat onto
clutch pack.
a. See Figure 5-21 . Align square openings of pressure
plate and diaphragm spring so that the assembly can
be installed over prongs on clutch hub.
b. Position spring seat with its larger outer diameter side
toward diaphragm spring.
NOTE
See Figure 5-22 . Turn compressing tool handle only the
amount required to install spring seat and snap ring.
Excessive compression of diaphragm spring could damage
clutch pressure plate.
c. See Figure 5-22 . Install SPRING COMPRESSING
TOOL (Part No. HD-38515-A)onto clutch hub against
diaphragm spring.
d. Place a wrench on the clutch spring forcing screw
flats to prevent the forcing screw from turning.
e. Turn compressing tool handle clockwise until dia-
phragm spring compresses just enough to install new
retaining ring into the groove in clutch hub prongs.
f. With retaining ring fully seated in groove of clutch
hub, carefully loosen and remove compression tool.
NOTE
When the compressing tool is removed, the diaphragm spring
will move outward forcing the spring seat up into the inside of
the retaining ring. The spring seat provides an operating surface
for the diaphragm spring at the same time preventing the
retaining ring from coming out during operation.
1
4
6
2
5
3
sm00286
1. Damper spring
2. Clutch hub
3. Steel plate
4. Narrow friction plate
5. Damper spring seat
6. Clutch shell
Figure 5-20. Clutch Pack Stack-Up (Cut-Away View)
5
4
2
1
3
sm00287
1. Diaphragm spring (pressure plate below)
2. Prongs on clutch hub
3. Retaining ring
4. Adjusting screw assembly
5. Spring seat
Figure 5-21. Spring Seat Installation
7
8
6
5
4
3
2
1
9
sm00280
1. Tool handle
2. Washer
3. Bearing
4. Bridge
5. Forcing screw
6. Diaphragm spring
7. Snap ring
8. Pressure plate
9. Spring seat
Figure 5-22. Pressure Plate Assembly
HOME
2009 XB Service: Drive/Transmission 5-15