Buell 2009 XB Series, Руководство по обслуживанию

Страница: 219 / 712

2.43
LEFT TAIL SECTION AND BATTERY PAN:
ULYSSES MODELS
DISASSEMBLY
1. Remove seat.
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explosion,
which could result in death or serious injury. (00049a)
2. See Figure 2-171 . Disconnect battery cables from battery:
negative cable (black) first.
3. Remove battery.
NOTES
• Before removing left tail section, it will be necessary to
remove certain components of the luggage system. See
2.54 LUGGAGE: XB12XT .
• The center tail loop must be removed before removing the
left or right tail sections. See
2.44 CENTER TAIL LOOP:
ULYSSES MODELS .
4. Remove center tail loop. See 2.44 CENTER TAIL LOOP:
ULYSSES MODELS .
5. See Figure 2-171 . Disconnect ECM connectors (4) [10],
[11] and [164].
6. Remove battery pan.
a. Remove ECM (3).
NOTE
When removing the ECM, the fastener closest to the shock
assembly has a nut that is captured in the plastic shield
below the ECM. You need to place your finger under the
nut when removing the fastener to prevent the nut from
falling out. Slide the ECM to one side and loosely install
the fastener to retain the nut in the correct location. The
rear fastener attaches directly to the battery pan.
b. Disconnect rear brake light switch connector [121].
c. Disconnect and remove Bank Angle Sensor (2) [134].
d. Remove fuse block and relay center (5).
e. Remove main harness and plastic grommet (7) from
battery pan.
f. Remove fasteners securing battery tray to left and
right tail sections.
g. Lift battery pan straight up and out.
7. Remove fastener securing left front trunk pan to left side
tail section.
8. Remove fasteners securing left tail section to main
frame/fuel tank assembly.
9. Remove left tail section.
10. Remove the trunk pan.
a. See Figure 2-171 . Remove the two fasteners securing
the preload adjuster to the trunk pan (13).
b. Remove the shock reservoir fastener and retainer.
Push the reservoir aside to access the fastener.
c. Remove remaining fasteners securing right front trunk
pan to right side tail sections.
d. Remove remaining components on trunk pan as
needed.
CLEANING
NOTE
Do not use wheel care products or other compounds developed
specifically for cleaning and polishing powdercoat. These
cleaners could potentially damage the tail section finish.
The cast aluminum tail section has a powder coat. Because
the surface is not bare polished aluminum, it must be cleaned
using only mild soap and warm water. After washing, always
dry the surface using a clean, soft cloth.
HOME
2009 XB Service: Chassis 2-141