Buell 2009 XB Series, Руководство по обслуживанию

Страница: 506 / 712

2. Install reflector bracket.
NOTE
Be sure tab on turn signal fits into hole in reflector bracket and
tab on reflector bracket fits into hole in enter tail section.
3. See Figure 6-55 . Attach turn signal using lockwasher and
jam nut (4). Tighten to 25-28 in-lbs (2.8-3.2 Nm).
4. Attach bullet connectors on turn signal wires as shown in
Figure 6-52 .
Be sure that all lights and switches operate properly before
operating motorcycle. Low visibility of rider can result in
death or serious injury. (00316a)
5. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were performed.
a. Turn ignition key switch to ON.
b. Activate left turn signals using switch on left
handlebar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left
handlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
6. Install seat. See 2.51 SEAT .
2
4
3
5
6
1
1
3
6
sm00455
5. 3. 1. Center tail section Reflector bracket Turn signal (2)
2. 6. 4. Turn signal bulb Bungee hooks Jam nut and lockwasher (2)
Figure 6-55. Rear Turn Signals: Lightning
ULYSSES
Remove
1. Remove seat. See 2.51 SEAT .
2. See 6.20 LICENSE PLATE LAMP ASSEMBLY, Ulysses .
Remove rear wire cover.
3. See Figure 6-53 . Separate left turn signal connector [18]
and right turn signal connector [19].
4. See Figure 6-56 . Remove jam nut and lockwasher (4).
5. Remove turn signal from license plate bracket (5).
Installation
1. See Figure 6-56 . Insert bullet connectors through license
plate bracket.
NOTE
Be sure tab on turn signal fits into hole in reflector bracket and
tab on reflector bracket fits into hole in enter tail section.
2. Attach turn signal using lockwasher and jam nut (4).
Tighten fastener to 25-28 in-lbs (2.8-3.2 Nm).
3. Attach bullet connectors on turn signal wires as shown in
Figure 6-53 .
4. Install wire cover. See 6.20 LICENSE PLATE LAMP
ASSEMBLY, Ulysses .
HOME
6-46 2009 XB Service: Electrical