Buell 2009 XB Series, Руководство по обслуживанию

Страница: 495 / 712

6.12 HEATED HAND GRIPS: ULYSSES MODELS
HEATED HAND GRIPS
Removal
1. Remove seat.
To prevent accidental vehicle start-up, which could cause
death or serious injury, disconnect negative (-) battery
cable before proceeding. (00048a)
2. Disconnect battery negative cable.
3. Remove the windscreen/windshield assembly from the
vehicle. See
2.48 WINDSHIELD AND WINDSCREEN:
LIGHTNING AND ULYSSES .
4. Unsnap the deflectors from the handlebar end caps, and
loosen the deflector attaching screws if necessary to swivel
the deflectors forward. See
2.28 DEFLECTORS:
XB9SX/XB12X/XB12XT/XB12XP .
5. Cut and discard the two cable straps on the right side of
the vehicle securing the heated hand grip wire to the
throttle cables and handlebar wiring harness.
6. Cut and discard the cable strap securing the heated hand
grip wire to the handlebar wiring harness below the right
side instrument cluster.
7. Cut and discard the cable strap securing the left side
heated hand grip wire to the instrument module connector.
8. Disconnect the two heated hand grip connectors below
the instrument cluster.
9. Remove the two fasteners that retain the left heated grip
to the handlebars and save fasteners for installation.
10. Remove left heated hand grip.
11. Remove right side heated hand grip. See 2.24 THROTTLE
CONTROL .
Installation
1. Install the left heated grip and tighten fasteners to 14-16
in-lbs (1.6-1.8 Nm).
2. Install the right side heated hand grip to the handlebar.
See
2.24 THROTTLE CONTROL .
NOTES
• See Figure 6-32 . The paint mark needs to be lined up
visually with the inside edge of the right (and left) hand
control.
• See Figure 6-33 . The hanging loop is critical to the life of
the heated grip wire, especially on the right hand grip, as
it is in motion when the motorcycle is ridden. In order to
maintain the wire loop, secure the right hand grip wire to
the throttle cables.
2
1
sm05236
1. Mark on left-side hand grip wire
2. Inboard edge of handlebar switch
Figure 6-32. Painted Alignment Mark for Hanging Wire
Loop, Left Side
2
3
1
sm05234
1. Mark on right-side hand grip wire
2. Inboard edge of handlebar switch
3. Strap wire to throttle cables
Figure 6-33. Painted Alignment Mark for Hanging Wire
Loop with Cable Strap, Right Side
NOTE
With the first cable strap in place on the right hand heated grip
wire, rotate the throttle grip and make sure the wire loop can
not touch any part of the hand control. If it does, make the loop
slightly larger until it can no longer makes contact when rotated.
3. See Figure 6-34 . Install the next cable strap on the right
side just below the second handle bar wire harness
retainer.
HOME
2009 XB Service: Electrical 6-35