Buell 2009 XB Series, Руководство по обслуживанию

Страница: 360 / 712

Connect positive (+) battery cable first. If positive (+) cable
should contact ground with negative (-) cable connected,
the resulting sparks can cause a battery explosion, which
could result in death or serious injury. (00068a)
3. Connect battery positive cable (red) first, tightening to
72-96 in-lbs (8-11 Nm). See
1.5 BATTERY MAINTEN-
ANCE .
4. Connect negative battery cable, tightening to 72-96 in-lbs
(8-11 Nm).
NOTE
If the ECM was replaced with a new component, it will be
necessary to download the correct calibration using D.T.
DIGITAL TECHNICIAN (Part No. HD-48650) and perform the
TPS zero procedure.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
5. Install seat.
NOTES
• The Throttle Position Sensor Zero Procedure should be
performed if the throttle position sensor or ECM have been
replaced or if the ECM has been recalibrated. See
4.5 THROTTLE POSITION SENSOR (TPS) .
• The throttle body has a throttle plate stop screw that is
preset at the factory and has tamper proof paint applied
to the head of the screw. Do NOT attempt to adjust this
screw. Tampering with this screw will require throttle body
replacement.
sm00857
Figure 4-7. Electronic Control Module (ECM): Lightning
(Typical)
sm00858
Figure 4-8. Electronic Control Module (ECM): Lightning
(XB12Ss)
ULYSSES
TOOL NAME PART NUMBER
DIGITAL TECHNICIAN HD-48650
Removal
1. Remove seat.
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explosion,
which could result in death or serious injury. (00049a)
2. Disconnect battery. See 1.5 BATTERY MAINTENANCE .
3. Disconnect ECM black connector [10] and gray connector
[11].
4. Remove the two fasteners to detach electronic control
module from bracket.
NOTE
When removing the ECM, the fastener closest to the shock
assembly has a nut that is captured in the plastic shield below
the ECM. You need to place your finger under the nut when
removing the fastener to prevent the nut from falling out. Slide
the ECM to one side and loosely install the fastener to retain
the nut in the correct location. The rear fastener attaches dir-
ectly to the battery pan.
Installation
1. Align holes in ECM with those in electrical bracket. Install
two fasteners and tighten to 36-60 in-lbs (4-6.8 Nm).
2. See Figure 4-9 . Attach ECM connectors [10] and [11].
HOME
4-8 2009 XB Service: Fuel System