Buell 2009 XB Series, Руководство по обслуживанию

Страница: 205 / 712

2.37 BELT GUARDS
REMOVAL
1. Place a scissor jack under jacking point and raise rear
wheel off ground. For location of jacking point see
4.18 EXHAUST SYSTEM .
2. Remove right side rider footrest support bracket.
3. Loosen rear axle pinch fastener.
4. Loosen rear axle approximately 15 rotations to allow partial
tension to be removed from rear drive system.
5. See Figure 2-163 . Remove lower belt guard (3) by
removing the fasteners (4).
6. Once the lower belt guard has been removed, remove the
metal stone guard (6).
7. Remove upper belt guard (1) by removing fasteners (2)
from swingarm.
INSTALLATION
1. See Figure 2-163 . Install upper belt guard (1) to swingarm
brace tightening fasteners (2) to 12-36 in-lbs (1.4-4 Nm).
2. Install stone guard (6) and tighten fasteners to 12-36 in-
lbs (1.4-4 Nm).
3. Install lower belt guard (3) and tighten fasteners (4) to
12-36 in-lbs (1.4-4 Nm).
4. Tighten rear axle. See 5.7 DRIVE BELT AND IDLER
PULLEY .
5. Tighten rear axle pinch fastener to 40-45 ft-lbs (54-61 Nm).
6. Install right side rider footrest mount and tighten fasteners
to 132-144 in-lbs (14.9-16.2 Nm).
7. Remove scissor jack from motorcycle.
5
1
2
6
8
4
7
3
sm00580
5. 1. Fasteners Upper belt guard
2. 6. Upper belt guard and stone guard fasteners (2) Stone guard
7. 3. Sprocket cover Lower belt guard
4. 8. Lower belt guard fasteners (2) Sprocket cover fasteners (2 short, 1 long)
Figure 2-163. Belt Guard Assembly
HOME
2009 XB Service: Chassis 2-127