BendPak PL-6000DC, Инструкция по установке и эксплуатации

Страница: 59 / 88

PL-6000DC Two Post Parking Lift
59
P/N 5900273 — Rev. A1 — May 2022
To lower and rest the Platform on a safety lock, rotate the Key Switch to the right (clockwise)
and
hold
until the Lift Platform rests on a lock.
Always walk around the Lift to inspect the Vehicle, never walk under the raised platform.
To park a Vehicle below the Lift Platform :
Once all precautions of the Pre-Lifting and Lifting Stage have been followed, drive the lower Vehicle
under the Lift Platform until the Tires reach the location where the car is positioned under the Lift to
allow clearance for the doors and mirrors.
Place the Vehicle’s gear selector in Park, turn off the Engine, and engage the safety brake. For
manual transmissions, shift to first gear, turn off the engine and set the safety brake.
When exiting the Vehicle use care not to damage the Vehicle’s doors or mirrors against the sides
of the Lift. Watch your head so as not to hit the underside or corners of the Lift Platform.
To remove the Lower Vehicle :
Verify the path is clear, then carefully drive the Vehicle out from underneath the Lift Platform.
To lower a Vehicle :
Walk around the Lift to verify there is nothing below or near the Lift Platform that could be
damaged.
Verify that no person (except the Lift Operator) is within 10-feet of the Lift area.
Turn and hold the Key Switch to the
left
(counterclockwise) and raise the Lift Platform off the
Safety Locks by a few inches.
Pull and hold the Safety Lock Release Handle, then rotate the Key Switch right (clockwise) to
lower
the Lift. You must hold the Safety Release Handle and the Key Switch turned full right until
the Lift Platform has returned to the ground.
When lowering the Lift always be watchful for objects, persons or animals that may wander under
the Lift Platform during operation. Cease operation immediately if the area under the Lift becomes
obstructed.
Keep hands and feet clear of all moving parts and pinch points.
Release the Key Switch back to its neutral position upon full descent of the Lift Platform.
Verify the path is clear, then drive the Vehicle off of the Lift Platform