BendPak PL-6000DC, Инструкция по установке и эксплуатации

Страница: 39 / 88

PL-6000DC Two Post Parking Lift
39
P/N 5900273 — Rev. A1 — May 2022
About Thread Sealants
Use Thread Sealant on NPT threads only. Liquid Thread
Sealant lubricates and fills the gaps between the Fitting
threads, and leaves no residue that could contaminate the
Hydraulic Fluid.
Other types of Thread Sealants (like Teflon Tape) can
shred during installation or removal and eventually enter
the Hydraulic System.
Thread Sealant can be used with most Hydraulic Fittings,
although you probably only need to use with NPT
connectors.
To apply Thread Sealant :
Make sure the NPT Fittings and connectors you are going to use are clean and dry.
If you are adding Thread Sealant to a Fitting or connector that has already been used with a
different sealant, use a wire brush to thoroughly remove the old sealant before adding more.
Leave the first 1-2 threads dry, without sealant. Apply a small amount of Thread Sealant (Loctite
5452 or similar) to the next four to five threads of the Fitting.
⚠
WARNING
Always wear the proper protective equipment when handling Thread Sealant.
You only need a small amount because the sealant spreads to the other threads as it is tightened
into place.
If you use too much, the excess liquid will be pushed out as the Fitting is tightened; use a rag to
remove the excess.
Hand tighten the Fitting into its connector, then turn with the appropriate wrench two to three turns
more; do
not
over tighten the Fitting!
Allow the
24 hour
manufacturer-recommended curing time before pressurizing the system.