SYSTEM INSTALLATION MANUAL
89000016
Table 1012. Personality Module Interface (Cont)
Pin
Signal
Electrical
I/O
Description
J1-43
CLK_PM
I
2
C
O
Personality module clock
J1-44
DATA_PM
I
2
C
I/O
Personality module data
NOTE:
1
The PM has no lightning protection so the wire length between the PM and the power and I/O connector
must be less than 4 inches (101.6 mm).
C.
Status LEDs
(1)
Four external LEDs on the front of the enclosure indicate general system status to the installer.
Table 1013 describes the LED states that can be observed.
Table 1013. LED States
Name
Description
Status
UAT system status (RED)
ON
UAT failure, troubleshoot system
OFF
UAT is operating normally
Flash fast
GPS fault condition or no position available
GPS status (GREEN)
Flash slow
GPS is acquiring satellites and determining position
Flash fast
GPS reporting a fault condition
ON
GPS has acquired satellites and is operating normally
GPS
OFF
GPS is not communicating
TX
UAT transmit (GREEN)
Blink ON
Blinks ON when ADS-B data is transmitted (once each second)
OFF
No UAT transmissions
Rx
UAT receive (GREEN)
Blink ON
Blinks on when ADS-B data is received
OFF
No UAT receptions
D.
KGX Control Panel Power
(1)
System ON/OFF power is remotely controlled using the REM ON pin (J1-32). The system will
power on when REM ON is grounded and power off when REM ON is open.
(2)
The KGX control panel uses the following KGX interfaces when installed:
• System ON/OFF remote power control, REM ON (J1-32)
EFFECTIVITY
ALL
Page 1012
22 Dec 2016
© Honeywell International Inc. Do not copy without express permission of Honeywell.