SYSTEM INSTALLATION MANUAL
89000016
B.
Entering Configuration Mode
CAUTION:
DO NOT USE CONFIGURATION MODE IN FLIGHT.
(1)
To enter configuration mode on the KGX control panel, complete the following steps:
(a)
Hold down the FN button while turning the mode selection knob from OFF to any
operating mode.
(b)
In the configuration mode the KGX control panel displays the messages on the screen as
shown in Figure 3048. Software versions shown can be the same or later depending on
the actual version of software installed.
Figure 3048. (Sheet 1 of 1) Configuration Mode Display
C.
Configuration Mode Operation
(1)
General
(a)
Configuration items can be changed using the CODE knob and the ENT button. Pressing
FN advances to the next configuration item.
(b)
The following paragraphs detail the setup modes available for configuring the KGX.
(2)
Aircraft Mode S (or ICAO) Address
(a)
The Mode S address is a 24-bit number assigned to the aircraft and is represented in
a 6-character hexadecimal format. The rotary CODE knob is used to change each
character as required. Each character of the Mode S address is a number between 0 and
9 or a letter between A and F. When the ENT key is pressed the cursor advances to the
next character as shown in Figure 3049.
(b)
To advance to the next configuration item without changing the ICAO address either scroll
through the six characters by pressing the ENT key six times or press the FN key.
Figure 3049. (Sheet 1 of 1) Aircraft Mode S (or ICAO) Address Display
EFFECTIVITY
ALL
Page 3042
22 Dec 2016
© Honeywell International Inc. Do not copy without express permission of Honeywell.