SYSTEM INSTALLATION MANUAL
89000016
Table 3007. Serial Port Output Configuration Settings (Cont)
2
Xpndr-Monitor selection requires a serial input and output port for operation. If, i.e., Port 2 output is set
to Xpndr-Monitor then serial Port 2 input is automatically used for Xpndr-Monitor input and serial Port 2
input should be set to ‘UNUSED’. Only used with FTM-190C at 9600 baud rate. The internal Xpndr-Monitor
function is set in accordance with
Paragraph 4.E.
Step (13).
3
Setting Disp-Cntrl for an input port must correspond to setting a display output on the same output port.
i.e., if serial Port 6 output is set to MX-20 or Traffic-Alert then serial Port 6 input can be set to Disp-Cntrl to
enable control.
4
For proper traffic and status presentation on legacy displays, review display settings in
Paragraph 4.F.
Steps (3) and (4) and set accordingly.
5
When using the KGX WiFi transceiver, make sure that the port is configured for Traffic Alert.
6
Configure at baud rate of 38400 when using Chelton Flight Logic display. Make sure that the CSA bit is
set in accordance with
Paragraph 4.F.
Step (3).
Table 3008. Serial Port Output Baud Rate Settings
Setting
Description
4800, 9600, 19200,
38400, 57600, 115200
These baud rates are typical for RS-232 or RS-422 equipment but the correct
rate must be selected to match the interfacing equipment’s configured or
default baud rate.
230400, 460800
These high baud rates are not normally recommended for RS-232 serial ports.
(4)
ARINC 429 Port Input Configuration
(a)
The ARINC 429 input data formats and speed configuration settings are described
in Table 3009 and Table 3010.
Table 3009. ARINC 429 Port Input Configuration Settings
Setting
1
Interface
Description
UNUSED
(not used)
-
No connection to ARINC 429 input port.
ADC
(Air Data Computer)
Altitude Input
Altitude, Airspeed, Vertical Rate data input. Format for air data
sensors and computers that output the ADC Labels listed in
Table 3014.
ADC&AHRS
(ADC+AHRS)
Altitude & Heading
Input
Altitude, Airspeed, Vertical Rate, & True Heading data input.
Format for devices that output the Labels listed in Table 3014
and Table 3015.
AHRS
(AHRS)
Heading Input
True Heading data input. Format for devices that output the
True Heading Label 314
Transpndr-Cntrl
(Txpdr Control)
Heading Input
Squawk code, IDENT, and call sign. Format for transponders
or controllers that output the ARINC Transponder Control Data
Labels listed in Table 3013.
GPS-743
(GPS)
GPS Input
GPS position, velocity, time, and integrity data input. Format
for the sensors that output the ARINC 743A labels (listed in
Table 3011) and ALSO outputs a Time Mark that is UTC
second synchronized.
EFFECTIVITY
ALL
Page 3012
22 Dec 2016
© Honeywell International Inc. Do not copy without express permission of Honeywell.