SYSTEM INSTALLATION MANUAL
89000016
(24) UAT Receiver Installed
(a)
The display screen is as shown in Figure 3073 with either YES or NO options.
(b)
Rotate the CODE knob either clockwise or counterclockwise to display either YES or NO
and select the correct option. Once selected, press the ENT key to confirm selection and
move to the next configuration item in the configuration mode.
Figure 3073. (Sheet 1 of 1) UAT Receiver Installed Display
(25) UAT Antenna Diversity
(a)
The KGX supplies the flexibility for installing either one or two approved UAT antennas. A
single antenna can either be installed on the top of the aircraft fuselage or on the belly of
the aircraft. When two antennas are installed they are installed on the top and bottom of
the aircraft. The following options can be selected:
• Top only
• Bottom only
• Dual.
NOTE:
The default value is set at “Bottom Only”.
(b)
The display screen is as shown in Figure 3074.
(c)
Rotate the CODE knob either clockwise or counterclockwise to display the correct
antenna diversity option. Once selected, press the ENT key to confirm selection and
move to the next configuration item in the configuration mode.
NOTE:
It is recommended to install dual antennas for maximum coverage.
NOTE:
Top only installations are not allowed at this time.
Figure 3074. (Sheet 1 of 1) UAT Antenna Diversity Display
(26) Check Ground on UAT Antenna
(a)
Confirm if the UAT antenna(s) used have a ground connection that allows the KGX
150T/130T to check if the antenna is installed by selecting the YES or NO options. Rotate
the CODE knob either clockwise or counterclockwise to display either YES or NO and
select the correct option. The display is as shown in Figure 3075.
(b)
Once selected, press the ENT key to confirm selection and complete the configuration
setup.
EFFECTIVITY
ALL
Page 3055
22 Dec 2016
© Honeywell International Inc. Do not copy without express permission of Honeywell.