SYSTEM INSTALLATION MANUAL
89000016
Figure 3039. (Sheet 1 of 1) “set disableSquawkTx” Command
F.
Display Output Settings
(1)
This section describes configuration settings for controlling traffic display output typically
for legacy displays.
(2)
“set max trgs” Command
(a)
This command sets the maximum number of targets to be sent on any configured
serial or ARINC 429 port configured for traffic display output. This is typically used to
limit the number of traffic targets for displays that can’t process a large number of traffic
targets. Refer to Figure 3040.
Figure 3040. (Sheet 1 of 1) “set max trgs” Command
(3)
“set cheltonCSA” Command
(a)
This command enables/disables the (Conflict Situational Awareness) CSA bit in the
Heartbeat message of the “Traffic-Alert” protocol. This parameter defaults to “disable”
and must ONLY be set to “enable” when interfacing to a Chelton FlightLogic Display. The
legacy Chelton display is not TSO-C195a compliant and requires this Heartbeat message
bit to be set or it will generate an ADS-B failure. The KGX does not implement a Conflict
Situation Awareness (CSA) algorithm since DO-217A and TSO-C195a do not currently
specify any CSA applications. For all other displays leave this parameter at the default
setting of “disable”. Refer to Figure 3041.
Figure 3041. (Sheet 1 of 1) “set cheltonCSA” Command
EFFECTIVITY
ALL
Page 3038
22 Dec 2016
© Honeywell International Inc. Do not copy without express permission of Honeywell.