SYSTEM INSTALLATION MANUAL
89000016
E.
ADS-B Transmit Settings
(1)
This section describes configuration settings mainly for transmitting ADS-B messages. Some
of these settings are relevant for receiver only units as well.
(2)
“set addr” Command
(a)
This command is used to set the ICAO address of the aircraft. For example, to set the
ICAO address to ABCD12, enter “set addr ABCD12”. The ICAO address must be entered
as a hex value. The KGX requires the ICAO to be set to the aircraft’s registered ICAO
address. This must be set for all KGX products. Refer to Figure 3027.
Figure 3027. (Sheet 1 of 1) “set addr” Command
(3)
“set call sign” Command
(a)
This command sets the default call sign of the aircraft and is typically the aircraft tail
number. For example, to set the call sign to ABCD1234, enter “set call sign ABCD1234”.
The default call sign is transmitted by a transceiver if a call sign setting is not received
from a configured transmit controller (transponder, KGX control panel, etc.). In a receiver,
the default call sign is for informational purposes only. Refer to Figure 3028.
Figure 3028. (Sheet 1 of 1) “call sign” Command
(4)
“set gps” Command
(a)
This command sets the system design assurance level for the GPS input. Internal
GPS must be set to Level C. For external GPS units refer to the GPS manufacturer’s
data for setting system design assurance level. This must be set for all KGX products.
Refer to Figure 3029.
Figure 3029. (Sheet 1 of 1) “set gps” Command
EFFECTIVITY
ALL
Page 3033
22 Dec 2016
© Honeywell International Inc. Do not copy without express permission of Honeywell.