Infinity WF Operator Manual
Page 26 of
117
S008459 Rev C
4.1.1
Self Test 1 Screen
Figure 4.1: Self Test 1 screen
The following functions are accessed from the Self Test 1 screen: IP Address; White Balance;
Lamp On/Off; Transport control arrows; and Exit Self test.
IP Address (Network Setup)
For communication the Infinity WF uses TCP/IP to quickly and efficiently transfer data over a
network connection.
To setup a connection on a network BBH recommends using only the supplied Ethernet cables.
Note
See section 1.4 Component Identification,
Left Side of Scanner
for location of
Ethernet Network Cable Connector. If you are not familiar with computer networking
or TCP/IP connectivity please consult an IT professional before proceeding any
further
.
To setup the Infinity WF scanner on your network begin by entering a valid IP address
using the following procedure:
1. Tap
the
IP Address
button on the Self Test 1 screen. The Network Setup screen will be
displayed
Figure 4.2: Network Setup screen
2. Tap the Address field (area where the IP address 192.168.115.223 is displayed) to open the
numeric keypad that allows you to enter your valid IP address
This screen allows you to enter the:
•
IP
Address
•
Gateway
•
Netmask
•
DHCP
The
Default
button resets the IP
address to original factory setting.
