Baker Hughes Panametrics PanaFlow LC, Руководство пользователя

Страница: 53 / 146

10. If Steps 4, 5 and 6 were successfully completed and
verified, the Analog output is successfully calibrated.
11. Once calibration is complete, select either [Save] or
[Save and Logout] option to save calibration data.
Figure 64: Optional I/O Analog Output Channel 1 and
Channel 2 connections
3.5.5c Option IO (slot2): setting up analog input
Use steps as in section “Log-in and Primary Pages” to
navigate to the Input/Output settings page.
1.
Highlight [Option I/O (Slot 2)] and press [ENTER].
2. Then highlight [AO-AO-AI-R-1000-3W] and press
[ENTER]. Then highlight [Analog Input(S2:3)] and press
[ENTER].
3.
If you do not wish to connect an Analog Input, you
should turn Analog Input selection to OFF.
4.
If you are connecting an Analog Input, choose [4-
20mA] option. Figure 65 below, shows the options available.
5.
Select the Measurement to input over 4-20mA input,
followed by the [Base Value] and [Full Value] selection. Refer
to Table 3 to see measurement options available for Analog
output.
Table 15: Analog input measurement types
Measurement Options for Analog Input
Temperature, Pressure
41