Baker Hughes Panametrics PanaFlow LC, Руководство пользователя

Страница: 51 / 146

3.5.5 Option I/O slot-2 (optional)
For extended I/O capability XMT1000 supports an Optional
I/O that provides 2 additional Analog Outputs (AO-AO), with
up to 2 Analog Inputs (AI-AI) or 2 RTD (R-R) inputs. See Table
14 for all available options.
Table 14: Optional I/O available options
Board Option # Input / Output Options Available
1 AO-AO-AI-AI
2 AO-AO-AI-R 3 Wire, 100 Ohm
3 AO-AO-R-R 3 Wire, 100 Ohm
4 AO-AO-AI-R 4 Wire, 100 Ohm
5 AO-AO-R-R 4 Wire, 100 Ohm
6 AO-AO-AI-R 3 Wire,1000 Ohm
7 AO-AO-R-R 3 Wire, 1000 Ohm
8 AO-AO-AI-R 4 Wire, 1000 Ohm
9 AO-AO-R-R 4 Wire, 1000 Ohm
In this chapter AO-AO-AI-R 3 Wire,1000 Ohm option will be
used as an example. Other options have similar capabilities
and menu map.
3.5.5a Option IO (slot2): setting up analog
output
Use steps as in section “Log-in and Primary Pages” to
navigate to the Input/Output settings page.
1. Highlight [Option I/O (Slot 2)] and press [ENTER].
2. Then highlight [AO-AO-AI-R-1000-3W] and press
[ENTER]. Then highlight [Analog Output(S2:1)] or [Analog
Output(S2:2)] and press [ENTER].
3. If you do not wish to connect an Analog Output, you
should turn Analog Output selection to OFF.
4. If you are connecting an Analog Output, choose 4-20mA
option. Figure 63 below, shows the options available.
5. Select the Measurement to be sent out on the 4-20mA
output, followed by the [Base Value] and
[Full Value] selection. Refer to Table 3 to see
measurement options available for Analog output.
6. Select [Error handling]. Refer to Section 3.5.5b to choose
an option that suits your needs.
39