Baker Hughes Apollo 3, Руководство пользователя

Страница: 150 / 277

Copyright 2020 Baker Hughes Company. All rights reserved. Page 150 of 277
Table 38: PID Speed Control Mode Parameters (cont'd.)
Parameter Description
Source1 The channel supplying the current to compare
against the Setpoint. By default, this is the
downhole tool Intake Pressure channel.
Pump Speed Ctrl Speed control output (i.e. drive frequency
commanded by Apollo at this time). It will
reflect the PID output if 055 Drive Mode
is
“PID Speed Ctrl” and Trigger 159 “Run
SpdCtrl
PID” is SET. This is NOT a
parameter to be edited. It is a channel
(Chan 076 Pump Speed Ctrl) included on
this screen for information purposes.
Run SpdCtrl PID Trigger 159
“Run SpdCtrl PID” is used to
control when the PID should be run if M055
Drive Mode is set to PID. If T159 is CLEAR,
(not SET), the PID will not be run and the
Manual Frequency setting for the current
system mode will be used as the output.
Select this trigger to access its Trigger Info
screen to adjust as needed. By default, the
PID will be run whenever the drive is running
and has reached the Start Frequency.
Low Clamp
Minimum drive speed that the PID control will
output. Leave at the default 0 to use the drive
Minimum Frequency.
High Clamp Maximum drive speed that the PID control will
output. Leave at the default 0 to use the drive
Maximum Frequency.
Mtr PID Rev.Act Parameter that describes the
PID’s output
relationship to the control value. A PID is
forward acting if increasing the speed of the
drive increases the control value (i.e. running
the drive faster creates more downhole
current). A PID is reverse acting if increasing
the speed of the drive decreases the control
value (i.e. running the drive faster decreases
the fluid level in a tank that is being pumped
out of). Change as needed to match the
relationship between the pump speed and the
Source1 variable.