Avaya IP500, Руководство по установке

Страница: 200 / 442

Installing IP500/IP500 V2 Page 200
15-601042 Issue 28c (19 August 2013) IP Office 9.0
9.9 Receiving the Configuration
The process here applies to systems running IP Office 3.2 and higher.
Objective - Receive a configuration from an IP Office running IP Office 3.2 or higher
software.
Information Required
·
o Service User Name and Password
The defaults for full configuration access are Administrator and Administrator.
However these should have been changed as part of the installation process, see
Configuring Security Settings.
Procedure: Receiving the Configuration
1. Select Start | Programs | IP Office | Manager.
2. Click in the main toolbar or select File | Open Configuration from the menu bar.
3. The Select IP Office window appears. After a few seconds it should list the control unit that is being setup. The
default name used is the control units MAC address.
·
If the system required was not found, the address used for the search can be changed. Enter or select the
required address in the Unit/Broadcast Address field and then click Refresh to perform a new search.
4. Click the check the box next to the system and then click OK.
5. The name and password request is displayed. The name and password must match one of those setup through the
security settings. The default name and password for full configuration settings access is Administrator and
Administrator.
6. Successful receiving of the configuration is shown by the full configuration tree being shown in the left-hand panel.
With no configuration loaded the navigation pane shows just BOOTP and Operator entries.
IP Office Default Settings
The following are the basic default configuration settings for an IP Office system.
Network Settings LAN Port (LAN1) WAN Port
(LAN2)
IP address 192.168.42.1. 192.168.43.1
IP Mask 255.255.255.0 255.255.255.0
DHCP Mode Client Client
No of DHCP IP Addresses 200. 200.
Extensions and Users
A user is automatically created for each physical extension port detected in the system. Users are assigned extension
numbers starting from 201. User names take the form Extn201, Extn202, ....
·
Hunt Group
A single hunt group 200 called Main is created and the first 10 users are placed into that hunt group as members.
·
Incoming Call Routes
Two default incoming call routes are created. Voice calls are routed to the hunt group Main. Data calls are routed to
the RAS user DialIn.