User and Programming Manual
22 XDS
Series
3.3 Input / Output Connectors
Table 3-1
lists all external connections for the XDS Series. Table 3-2 and Table 3-3
provide input
and output connector descriptions.
NOTE:
DO NOT REVERSE THE EXT. SENSE CONNECTION POLARITY OR
DAMAGE TO THE XDS SUPPLY WILL RESULT.
For permanently connected equipment, a readily accessible disconnect device shall be
incorporated in the fixed wiring. For equipment connected through an outlet socket, the outlet
must be installed near the equipment and must be easily accessible.
NOTE:
For proper connection to the mains, a suitable circuit breaker or fuse is
required. The rating will depend on the units' nominal AC input voltage. If a
fuse is used, a suitable disconnect device should be installed to allow AC
input to be removed from the supply.
NOTE:
When connecting the AC Input wiring, DO NOT APPLY MORE THAN 32
INCH POUND (equivalent to 2.67 lbf feet or 3.62 Nm) of torque to the input
terminal connection studs and screws.
Table 3-1: Rear Panel Input and /Output Connectors
Connector
AC Input
Function
Connects To
L1 – AC in
L2 – AC in
L3 – AC in
CHASSIS - GND
Primary AC Power Input
208 - 230 VAC nominal (Std)
400 VAC nominal
480 VAC nominal
Limit torque applied to 32 inch pound force/
2.7 foot pond force / 3.6 Nm.
DC Output
Function
Connects To
Positive Bus Bar
Negative Bus Bar
DC output
User Load
Table 3-2
Other
Function
Table
Isolated Analog I/O
Control Interface (option)
DB15, J22, Table 3-5
RS232
Control Interface
DB9, J20, Table 3-4
Auxiliary I/O
Misc.
DB9, J21, Table 3-6
Remote Inhibit
Output shut-off
DB15, J22, Table 3-5
IEEE-488
Control Interface (option)
GPIB 24 pin, J23. See IEEE-488 standard
for pin out.
Table 3-2: Output Connection Description
Supply Type
Connection Description
For Output voltages <= 60V
Bus Bar with threaded Stud.
(Do not exceed 10 foot
pound force / 13.5 Nm of torque when tightening
nuts of bus bars)
For Output Voltages > = 80V
Bus Bar with threaded Stud and a rear safety cover
(Do not exceed 10 foot pound force / 13.5 Nm of
torque when tightening nuts of bus bars)
Содержание XDS 100-100
