Arcteq Generator Commander, Инструкция по эксплуатации

Страница: 178 / 561

Figure. 5.4.17 - 85. Long time constant thermal image calculation.
Where:
• θ
t-1
= Thermal image status in a previous calculation cycle (the memory of the function)
• I
EM
= (see below)
• I
N
= Current for the 100 % thermal capacity to be used (pick-up current in p.u., with this
current t
max
achieved in time t)
• k
SF
= Loading factor (service factor) coefficient, the maximum allowed load current in p.u.,
depending on the protected object
• k
AMB
= Temperature correction factor, either from a linear approximation or from a settable
ten-point thermal capacity curve
• e = Euler's number
• t = Calculation time step in seconds (0.005 s)
• τ
1h
= Long thermal heating time constant of the protected object (in minutes)
• τ
1c0
= Long thermal cooling time constant (motor stopped) of the protected object (in
minutes)
• τ
1cr
= Long thermal cooling time constant (motor running) of the protected object (in minutes)
• W
f
= Correction factor between the times t
1
and t
2
Figure. 5.4.17 - 86. Short time constant thermal image calculation.
Where:
• θ
t-1
= Thermal image status in a previous calculation cycle (the memory of the function)
• I
EM
= (see below)
• I
N
= Current for the 100 % thermal capacity to be used (pick-up current in p.u., with this
current t
max
achieved in time t)
• k
SF
= Loading factor (service factor) coefficient, the maximum allowed load current in
p.u. value, depending on the protected object
• k
AMB
= Temperature correction factor, either from a linear approximation or from a settable
ten-point thermal capacity curve
• e = Euler's number
• t = Calculation time step in seconds (0.005 s)
• τ
2h
= Short thermal heating time constant of the protected object (in minutes)
• τ
2c
= Short thermal cooling time constant of the protected object (in minutes)
• W
f
= Correction factor between the times t
1
and t
2
The equation below is that of the effective current of the protected object including the TRMS
measurement maximum phase current as well as a possible phase current unbalance condition.
Genera Generattor Commander or Commander
Instruction manual
Version: 2.07
176 © Arcteq Relays Ltd
IM00001