ACU-RITE MILLPWR G2, Техническое руководство

Страница: 77 / 546

4.2 Managing Parameters 77
Reaction to change The following reactions can occur when machine parameters are changed:

NOTHING

RUN

RESET

REF
Information on which reactions occur for which machine parameters is given
later in this chapter. See "Overview of the Machine Parameters" on page 93..
Reaction NOTHING
Data with this reaction can be changed at any time, including during program
run.
Reaction RUN
Changes are only possible during a PLC strobe or NC stop.
Reaction RESET
After a machine parameter to which the RESET reaction is assigned has been
changed, the error message
Machine parameters were changed. Shut down
and restart the control
is displayed.
This message cannot be cleared. The machine must be restarted. The control
can also be restarted later so that you can make further changes in the config-
uration editor.
Data objects with this reaction must not be changed during program run.
Reaction REF
After a machine parameter connected to the REF reaction has been changed,
the affected axis is set to unreferenced.
A new reference run must be made for this axis.
Data objects with this reaction must not be changed during program run.
4.2.5 Update Rules
Use the UPDATE RULES key to define rules that are required for updating the
machine parameters during a software update.
When new objects are added, or existing ones deleted, the OEM must update
the reference to the parameter file here.
These rules no longer need to be followed after the software has been
exchanged.