ACU-RITE MILLPWR G2, Техническое руководство

Страница: 382 / 546

382 ACU-RITE Technical Manual MILLPWR
G2
Trigger conditions:
Specify the trigger conditions in the following input fields:
 Trigger: Set the trigger condition.
• Single shot: After pressing the soft key, the next 3000 events are stored.
• Free run: The recording is started and ended by soft key. If you press the
Stop
soft key, the last 3000 events (at most) are stored.
•
Channel 1
to
6:
Recording begins when the trigger condition of the
selected channel is fulfilled.
• Channel 1 + L to channel 6 + L: Recording begins when the trigger con-
dition of the channel selected here as well as the trigger conditions of the
digital signals (trigger condition “logic”) are fulfilled. The trigger conditions
are AND-gated.
•
Logic:
Recording begins when the trigger condition of the digital signals
is fulfilled (trigger condition “logic”).
 Edge: Set when triggering is to occur:
•
+
: Trigger at rising edge
•
–
: Trigger at falling edge
 Trigger threshold: Enter the trigger threshold (you will find the appropriate
units in the signals table on Seite 408).
 Pre-Trigger: Select a value from the selection box.
Recording begins at a time preceding the trigger time point by the value
entered here
The Output and Feed rate F fields are reserved.