ACU-RITE MILLPWR G2, Техническое руководство

Страница: 490 / 546

490 ACU-RITE Technical Manual MILLPWR
G2
kanalStatus Possible channel states:

rapidFeedActive: Rapid traverse is active for this
channel

ncStopTasterActive: PLC request for NcStop at trig-
gering of touch probe

override100Active: The override is frozen at 100%

singleStepActive: Single Block is active

ncStartActive: NC start is active

internStartActive: Internal NC start is active

systemCycleActive: A system cycle is active

ncStopActive: NC stop is active

programStopActive: Program stop (M00/M01) is
active

cancelActive: Cancellation is active

threadCycleActive: A thread cycle is active

tProbeCycleActive: Touch probe cycle is active

tasterMonitorGeo: NC requests touch probe to be
monitored

tasterMonitorPlc: PLC requests touch probe to be
monitored

measure: The touch probe has triggered

revolFeedProgRun: Feed rate per revolution in auto-
matic mode is programmed for this channel.

revolFeedManualMode: Feed rate per revolution in
manual mode is programmed for this channel.

staticMask: Used internally.
chainState Status of the IPO chain:

IPO chain is “full.”

IPO chain is “empty.”

IPO chain is “almost empty” (waiting for the last ack-
nowledgment message)
chainCount Number of acknowledgment messages in the IPO
chain
satzCount Number of blocks in this NC program.
blockId ID of the current block
blockNumber Number of the current block (from NC program)
fileName Current NC program
IdWaitK0 Waiting ID during the synchronization of KanalObjek
and IPO
IdStartK0 Starting ID during the synchronization of KanalObjek
and IPO
(The starting ID must be greater than or equal to the
waiting ID for the process to continue)
Variable Display