ACES SYSTEMS Cobra II, Руководство пользователя

Страница: 67 / 438

Gen II
User Manual
4-16 – Propeller Balance Chapter 4 Revision 2.2, Apr 2020
4.1.1.3.2. When all fields are completed to your satisfaction, press the [OK] key to accept
the inputs and continue to the “Prop Hole Layout Setup”.
4.1.1.4. – Prop Hole Layout Setup
If “Yes” was selected under the “Holes:” entry in paragraph 4.1.1.1.7 the “Prop Hole Layout
Setup” banner screen is the next screen displayed. Note that if you have selected a two (2) engine
setup, the Hole Layout for #1 engine will be displayed and completed first, then the action must
be repeated for engine #2.
4.1.1.4.1. The “Name” field is automatically filled in with “Eng 1(2) Hole Layout”.
Complete the fields on the screen by doing the following:
4.1.1.4.2. Use the [

] key to move to the “No. of Holes” field. Enter the number of holes
that correspond to the total number of trim weight mounting locations. The valid
range of values for this field is 1 to 36.
4.1.1.4.3. Move to the “Space” field using the [

] key and then use the [

] key to select
“Even” or “Uneven” from the available selections. Even indicates that all trim
weight mounting locations are evenly spaced. The analyzer will automatically
calculate the number of degrees between holes in this case. If you select
“Uneven,” and then use the [

] key to move away from the field, several fields
(“Ang” and “No.”) appear at the bottom of the screen. You will complete these
Angle and Number fields later in the process at paragraph 4.1.1.4.6.
4.1.1.4.4. Use the [

] key to move to the next field, “Dir (FLA).” Complete this field by
using the [

] key, select CW for clockwise or CCW for counter-clockwise to