Gen II
User Manual
9-27 – Transient Balance
Chapter 9
Revision 2.10, Apr 2020
the class weight for that location and repeat until all existing weights are entered into
the analyzer and then press [OK] to continue.
9.2.5.9.
Pressing the “F6 Graph” key on the previous screen will present the “Run 1 Existing
Weights” Graph screen. This screen will give a graphical representation of the
existing weight and location information entered in the previous screen.
9.2.5.10.
If this is the first suggested weight screen, the weights will be test weights unless an
established influence was entered in the setup. Notice at the top of the screen that the
message “Remove Old Wts, Inst. New Wts” is shown. All previously installed
weights must be removed EACH TIME a new solution is installed. This means that
weights installed on the previous run of a balance job must be removed completely
before a new solution is installed. The example screen below shows the suggested
Содержание Cobra II
Страница 91: ...Chapter 5 RESERVED Revision 1 00 Dec 2014 ...
Страница 92: ...Chapter 6 RESERVED Revision 1 00 Dec 2014 ...