ABB FECA-01 EtherCAT, Руководство пользователя

Страница: 40 / 148

40 Start-up
FECA-01 configuration parameters – group B (group 2)
Note: The actual parameter group number depends on the drive
type. Group B (group 2) corresponds to:
•
parameter group 55 in ACS355
•
parameter group 53 in ACSM1, ACS580 and ACS850
•
parameter group is typically 53/56 (group 153/156 in some
variants) in ACS880 if the adapter is installed as fieldbus
adapter A/B.
For more information, refer the appropriate drive manuals.
All parameters in this group are handled by the adapter module
automatically. Do not modify the settings of these parameters.
FECA-01 configuration parameters – group C (group 3)
Note: The actual parameter group number depends on the drive
type. Group C (group 3) corresponds to:
•
parameter group 54 in ACS355
•
parameter group 52 in ACSM1, ACS580 and ACS850
•
parameter group is typically 52/55 (group 152/155 in some
variants) in ACS880 if the adapter is installed as fieldbus
adapter A/B.
For more information, refer the appropriate drive manuals.
All parameters in this group are handled by the adapter module
automatically. Do not modify the settings of these parameters.

Control locations
ABB drives can receive control information from multiple sources
including digital inputs, analog inputs, the drive control panel and a
communication module (for example, the adapter module). ABB
drives allow the user to separately determine the source for each
type of control information (Start, Stop, Direction, Reference, Fault
reset, etc.).
To give the fieldbus master station the most complete control over
the drive, the communication module must be selected as the
source for this information. The parameter setting examples below