ZyXEL Communications ALC1024, User Manual

Page: 46 / 255

Commands with EEC
3-12 Commands with EEC Introduction
Table 3-1 Commands with EEC
COMMANDS DESCRIPTION
MODULE COMMAND ATTRIBUTES
accept [ all | <if> ] [ none |
<versionList> ]
This command sets one or all interfaces
to either not accept RIP or accept a
specific RIP version.
allowed This command lists RIP versions allowed.
boot This command broadcasts RIP requests
for routes.
hostroutes This command allows RIP routes to
hosts.
hostroutes off This command disallows RIP routes to
hosts.
killrelay <relay> This command removes the specified RIP
relay.
poison This command kills the RIP routes
returning to their source.
poison off This command doesn’t kill the RIP routes
returning to their source.
relay <version> <relay>
[<if> [<timeout>]]
This command defines the RIP relay.
relays This command shows the active RIP
relays.
rxstatus This command prints the reception status.
send [ all | <if> ] [ none |
<versionList> ]
This command sends only the specified
RIP version routes on the list.
trigger This command triggers a broadcast of
routing information.
routes This command shows all routing entries.
stats help This command shows the help
information about the stats command.
arp This command shows the ARP statistics.
icmp This command shows the ICMP statistics.
ip This command shows the IP statistics.
raw This command shows the raw statistics.
tcp This command shows the TCP statistics.
udp This command shows the UDP statistics.
subnet add <netName> <if> <ip> <mask> This command creates a subnet.
delete <netName> This command deletes a subnet.
flush This command removes all subnets.
version This command shows the version
information for the IP module.