ZyXEL Communications ALC1024, User Manual

Page: 176 / 255

Web Configurator with EEC 2
SNMP 20-3
Figure 20-2 Edit SNMP Setup
The following table describes this screen.
Table 20-3 Edit SNMP Setup
LABEL DESCRIPTION
SNMP Setup Click this link to go to the SNMP Setup page.
Delete Select this check box to delete this set of SNMP access parameters.
Trusted Host If you enter a trusted host, your line card will only respond to SNMP messages from this
address. If you leave the field set to 0.0.0.0 (default), your line card will respond to all
SNMP messages it receives, regardless of source.
Read Community Enter the read community, which is the password for the incoming Get and GetNext-
requests from the management station. Public is the default.
Write Community Enter the write community, which is the password for incoming Set requests from the
management station. 1234 is the default.
Trap Community Enter the trap community, which is the password sent with each trap to the SNMP
manager.
Apply Click Apply to save your changes back to the line card's volatile memory. The line card
loses these changes if it is turned off or loses power, so use the Config Save link in the
navigation panel on the left to save your changes to the non-volatile memory when you
are done configuring.
Cancel Click Cancel to begin configuring this page afresh.