ZyXEL Communications ALC1024, User Manual

Page: 36 / 255

Commands with EEC
3-2 Commands with EEC Introduction
yields
version - show system software version
The system responds with a description of the
version
command.
3.1.3 Saving Your Configuration
Always remember to save your configuration using the following syntax:
192.168.1.1> config save
This command saves all system configurations into nonvolatile memory. Nonvolatile memory refers to the line
card’s storage that remains even if the line card’s power is turned off. Run time (memory) is lost when the line
card’s power is turned off. You must use this command to save any configurations that you make, otherwise the
line card will return to its default settings when it is restarted.
Do not turn off your IES-2000/3000 or remove the line card while saving your configuration.
3.2 Commands with EEC
The following table lists all of the commands that you can use with the line card when you use the Ethernet
extension card. Refer to the following chapters for descriptions of commonly used commands.
This user’s guide describes commands that are helpful for configuring the line card.
Using commands not documented in the user’s guide can damage the unit and possibly render
it unusable.
Table 3-1 Commands with EEC
COMMANDS DESCRIPTION
MODULE COMMAND ATTRIBUTES
bridge
config save This command saves the bridge’s run
time configuration to nonvolatile memory.
print This command shows the bridge’s run
time configuration.
reset This command reloads the bridge’s run
time configuration from nonvolatile
memory.
device This command shows the line card’s
bridge settings.
add <edd | xport/[1..24]> This command adds a bridge device.
delete <edd | xport/[1..24]> This command deletes a bridge device.
ethertype This command displays the types of
packets that the ports are set to forward.