ZyXEL Communications ALC1024, User Manual

Page: 52 / 255

Commands with EEC
4-2 System Commands
This command instructs the system to perform a configuration save and then a warm start, that is, restarting the
system without turning the power off and on.
4.2.4 Password Command
Syntax:
192.168.1.1> passwd
This command changes the management password. The management password is used for authentication at Telnet
login. The management password must be from one to eight characters long and any character is accepted. The
factory default password is “1234”.
It is very important that you remember your password. If you forget it, refer to the
Troubleshooting section for help.
4.2.5 Config Print Command
Syntax:
192.168.1.1> config print
This command lists all current system configuration settings.
4.2.6 Exit Command
Syntax:
192.168.1.1> exit
This command terminates the telnet management session.
4.3 Sys Commands
Enter
sys
at the command prompt to enter the sys commands subsystem.
4.3.1 Info Command
Syntax:
192.168.1.1 sys> info
This command displays system related information such as the line card’s name, contact person, location,
firmware version and build date, MAC address, chassis and slot IDs, and operation mode.