ZIEHL-ABEGG ZETADYN 3C, Original Operating Instructions

Page: 133 / 204

Condition of the DCP connection
The two LEDs "Error (red)" and "Run (green)" are available to diagnose the DCP connection.
LED LED status Operation condition
Error (rot)
fast
fl
ashing With activated DCP function, the DCP connection is not present or is
defective
Run (gr ü n)
On With activated DCP function, the DCP connection is
fl
awless
Error (rot) /
Run (gr ü n)
Slow alternat-
ing
fl
ashing
The DCP function is not activated in a trouble-free DCP connection
(only DCP3/DCP4)
Condition of the CAN connection
The two LEDs "Error (red)" and "Run (green)" are available to diagnose the CAN connection.
LED colour LED status Operation condition / error status
Run (gr ü n) fl
ashing once
per second Operation Mode "Stopped"
Run (gr ü n)
fast
fl
ashing Operation Mode "Preoperational"
Run (gr ü n)
on Operation Mode "Operational"
Error (rot)
Off no error, connection is in order
Error (rot) fl
ashing once
per second CAN error counter has exeeded the warning limit of 96 errors
Error (rot)
On Bus off, reset of the controller is necessary
13.2.1 Software update
If an error occurs during the software update, a
fl
ash code is issued by LED OP1 for the corresponding
error message.
An explanation of the
fl
ash code can be found in the chapter Special Functions/Software Update
13.3 Readout the error memory
Faults which lead to interruption of the travel are saved in a fault list.
The fault list can be found in menu
Statistik/ST_LST
. Up to 64 error messages can be managed.
Once the number of 64 messages has been reached, the oldest entry in each case is deleted for each
new error message which arises. When the fault list is called up, the last fault which occurred is
displayed with the following information:
? B R : F a h r t - F e h l e r ?
E 5 8 3 S 4 3 0 8 . 2 h
0 0 0 0 0 7 6 x x x 2 8 C
?
0 0
R V 1 5 . 9 1 m + 1 2 A
1
2
4
5
6
7
8
9
10
11
3
1 Error description
2 Error no.
3 Operation condition (S=status)
4 Travel number
5 Consecutive error number
6 Travel direction
7 Operating hours
8 Temperture power stage
9 Motor current consumption
10 Additional information (option)
11 Position of tha car in the shaft
Please refer to the "Error diagnosis
“
chapter for a description of the error number and the operating
condition.
Original operating instructions
ZETADYN 3C
Error diagnosis
R-TBA08_03-GB 1619 Part.-No. 00163322-GB
133/204