Chapter 11__
___________________________________________________
Zaxcom Fusion User’s Manual
162
Significant Change Reminders
Folder Recovery Operation
Boot up while pressing the F6 key (
INPUT
key
). Once the system has settled down, go to the folder that was
recovered and press the
REC
key
, wait 5 seconds and press the
STOP
key
. This causes the recovered data to be
written to the drive.
Saving and restoring Fusion's configuration INI files
Starting in version 5.14 an Export Settings feature was added to allow Users to save and restore all their settings
to or from any (FAT32 formatted) mirror disk.
To save the current configuration settings to a CompactFlash card:
1.
Turn
Off
mirroring and insert a formatted mirror disk or card.
2.
Go to the
Main Menu page
{
p.35
} and type
1967
to open the
Debug Screen page
{
p.128
}.
3.
Press the
TRIM
key
then the
5
key
. This will copy your configuration memory files to the mirror disk.
To load configuration settings from a CompactFlash card:
1.
Turn
Off
mirroring and insert a mirror disk or card containing the INI files to be loaded.
2.
Go to the
Main Menu page
{
p.35
} and type
1967
to open the
Debug Screen page
{
p.128
}.
3.
Press the
TRIM
key
then the
4
key
. This will load the INI files into the unit‟s configuration memory.
New Processor speed selection feature
DSP boards labeled REVB in the
About Fusion page
{
p.122
} might not be able to run reliably at the high
processor speed.
Type
036
in the
Main Menu page
{
p.35
} and go to the
Fusion Service Menu page
{
p.127
}.
There is a new
Processor Speed
button
. If the processor speed is set to
HIGH
, the
192000
button
in the
Sample
Rate page
{
p.55
} should remain enabled. If not, the
9
key
must be held during power up in order to allow 192
kHz recording.
The higher speed will increase the mirroring speed by about 20% and will allow the user to enable more effects
before the screen becomes sluggish.
NOTE:
Older Fusions may NOT run reliability at the higher processor speed.
To use the Simultaneous mirror feature:
Go to the
Mirror Drive page
{
p.111
} and change the
Mirror Mode
button
to
On-CONTIN.
to enable the
continuous mirror mode. Fusion will mirror the currently selected mirror folder while in record (not during
playback). When mirroring more than 8 tracks at 48 kHz, Fusion may slowly fall behind the mirror process and
may take a few minutes to catch up after the recording stops.
To use the “Mirror All Folders” feature:
Erase your mirror drive (FireWire hard drive) and then select a starting folder in the
Mirror Folders page
{
p.116
}. Press the
Mirroring Mode
button
to select
All Folders
. Then go back to the
Mirror Drive page
{
p.111
} and change the
Mirror Mode
button
to
On-NORMAL
to start mirroring. The Fusion will mirror
starting at the currently selected mirror folder and will mirror all folders until the end of the disk. Fusion will
over-write any matching segments that are already on the mirror disk.