ST950S Plus+ Installation and Commissioning Manual
Push the card into the socket slightly until it ‘clicks’ then release pressure. The card can now be pulled
from the socket.
To insert a card, align it with the socket with the contacts facing PCB and closest to the socket. Slide it
into the socket and apply slight pressure until it ‘clicks’. The card is now located correctly. The photos
below show the correct orientation for the card.
Important:
It is important that the card is not write protected. The ‘lock’ switch must be in the position
shown in the diagram below:
Figure 21. SD Card with Write Enable Switch
Figure 22. SD Card in Correct Orientation
Page 57
