YASKAWA CR700, Technical Manual, Page: 415 / 886

Periodic
Inspection
and
Maintenance
7
7.5 Replace the Drive
YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual 415
Figure 7.67 Permitted Angle
• Put the bit all the way into the hex socket to tighten the hex socket cap screw.
• When tightening straight-edge screws, hold the tip of the screwdriver in the center of the screw head. Do not let
the tip of the screwdriver slip out from the groove of the screw.
Figure 7.68 Tightening Slotted Screws
• After you connect the wires to the terminal block, lightly pull on the wires to make sure that they do not come
out of the terminals.
• Remove the correct section of the wiring cover to make wiring easier.
• Regularly tighten loose terminal block screws to their specified tightening torques.
• Do not let strain on the wiring cause damage. Use a strain relief near the wiring to release the tension. Refer to
Figure 7.69 for an example.
A - Strain relief
Figure 7.69 Strain Relief Example
Table 7.9 Recommended Wiring Tools
Screw Size Screw Shape Adapter
Bit
Torque Driver Model
(Tightening Torque)
Torque Wrench
Model Manufacturer
M4 Slotted (-) Bit SF-BIT-SL 1,0X4,0-70 PHOENIX CONTACT
TSD-M 3NM
(1.2 - 3 N∙m
(10.6 - 26.6 lbf∙in))
-
M5
*1
Slotted (-) Bit SF-BIT-SL 1,2X6,5-70 PHOENIX CONTACT
Wire Gauge ≤
25 mm
2
(AWG 10):
TSD-M 3NM
(1.2 - 3 N∙m
(10.6 - 26.6 lbf∙in))
Wire Gauge ≤
25 mm
2
(AWG 10): -
Wire Gauge ≥
30 mm
2
(AWG 8): -
Wire Gauge ≥
30 mm
2
(AWG 8):
4.1 - 4.5 N∙m
(36.3 - 39.8 lbf∙in)
*2
*3