XCMG XCT80, Operation Manual

Page: 98 / 250

XCT80 Truck Crane Operation Manual
6-18
This switch must be used when driving in
the fog, then the fog lamp indicator light and
front and rear fog lamps go on.
12. Warning light switch (optional) (7 in
Figure 6-10)
When this switch is pressed, the warning
lights begin flashing, and reset it when not
using.
13. Air conditioning switch (8 in Figure
6-10)
Press this switch, the air conditioning
begins to work, and reset when not using.
14. Emergency signal switch (5 in Figure
6-10)
When the vehicle must be parked in a
dangerous place, this switch should be pressed to
turn on the danger warning lights, then all turning
signal lights
fl
ash. When the danger warning needs
to be released, you should reset it. Even if the key
is in the OFF position, the danger warning lights
also play a role.
15. Differential locking switch (13 in
Figure 6-10) and differential indicator (18 and
21 in Figure 6-7)
During driving, when the rear wheels fall
in the pit and cannot drive, press this switch, the
differential locking indicator light goes on, open
the differential gas path through the solenoid
valve control, so that drive axle can be as rigid
coupling, so improve the passing ability of the
vehicle.
When using the differential locking
switch, you must note the following:
a. Before turning on or release the
differential lock, the power output of the
engine must be cut off, while the vehicle
should be in a stationary state;
b. When using this switch, the vehicle
must be kept straight driving, otherwise it
will damage the drive axle;
c. Once entering the good road, you
must immediately lift the differential lock.
Continuous use of this switch will cause
damage to the drive train and increase fuel
consumption.
The components and functions of lower crane portion
Chapter 6
16. Heater adjustment switch (1,2 and 10 in
Figure 6-10)
It can adjust the amount of wind, wind
direction and temperature according to the
demand.
17. Hand brake handle (7 in Figure 6-11
in the sequencer) and hand brake indicator
light (6 in Figure 6-7)
When the vehicle stops or the driver leaves
the vehicle, pull back the hand brake lever to
the locking position range of 55
°
~77
°
, and
then the hand brake indicator light goes on,
indicating that the vehicle has been parked.
When the vehicle starts, you should release the
Courtesy of CraneMarket.com