Westomatic Eco Encore, Technical Manual

Page: 12 / 150

11
INSTALLATION PROCEDURE
1. CONNECT WATER SERVICES
Water filters are not fitted as standard. If, however, the machine has provision
for a water filter, the filter will be packaged within the machine but not
connected. Ensure the filter is fitted before turning on the mains water supply.
The machine should be connected to a 15mm (1/2") mains water supply from a
rising main, or other suitable potable water supply, using B.S.P. fittings. There
should be a minimum water pressure of 1.40 Bar (20 psi). Flush the line
(several gallons) before connecting. The machine should be connected using
the new armoured hose supplied. Ensure the seal is fitted. The seal is of a
W.R.C. approved type - non-approved types should not be used.
SANITISATION
Whilst suitable steps are followed at Westomatic, which include a dosing
system, providing a suitable microbiological condition, it is necessary that
during installation the machine should be sanitised using a two-stage process.
Stage 1 biocide - for the removal of Biofilm build up
Stage 2 sanitise - neutralisation of bacteria
2. LOAD MACHINE WITH CUPS
1. Load ONE sleeve of cups into the carousel, avoiding the dispensing
position.
2. After the machine is switched on, the carousel will rotate until the cups
have dropped into the cup ring.
3. The remaining sleeves can then be filled.
Always ensure the carousel lid is fitted.
Overfilling of the carousel will prevent closure of the cup unit.
CUP UNITS
There are 2 different cup units for different sizes of cups. These are colour
coded as follows.
On no account should an attempt be made to turn the cup carousel by hand. If
the carousel locator is damaged then cup jams will almost certainly occur.
Red 200 ml (7 oz) tall T
Grey 250 ml (9 oz) S
Grey 200 ml (7 oz) squat S
Cup Peeler Colour Cup Type Cup Chute
Identification