Westomatic Eco Encore, Technical Manual

Page: 97 / 150

96
19. MICROPROCESSOR SYSTEM & SIMM LOGIC
Changing a control board
If it is necessary to change the CPU control board all audit data will be lost, if it
is possible, retrieve audit data using either the SIMM card or by taking prints 1
and 2. Audit report one will provide you with the sales data, and audit report
two will provide all Address settings that are to be reprogrammed into the new
CPU processor board once it has been fitted.
SIMM Card
Located on the CPU, the SIMM card read/writer provides an easy method for
auditing, up and downloading of machine parameters and upgrading of
software.
LOAD/READ CONFIGURATION – Address 21
1. Open door and operate door switch (power up)
2. Insert SIMM Card
3. Press the ‘Cancel’ button four times to enter “Service Mode”
4. Enter address 021 and press enter (Vend button)
5. Use Whipped/Extra White button to scroll up and down
(Copy)
6. Select READ CONFIG and press enter (Vend button)
7. Accept default AUTO SELECT file name by pressing enter again
8. Confirm the action by pressing Enter
9. Display shows READING…
10. When finished the display returns to the initial 021 setting
11. Operate door switch (power down)
12. Remove SIMM Card and Close door
(Clone) Follow same procedure except at 021 address…
13. Select LOAD CONFIG and press enter ( Vend button )
14. Use scroll buttons (Whipped/Extra White) to pick the appropriate file to
load into the machine
15. Press the ‘Vend’ key to accept and confirm action
16. Display shows WRITING …
17. When finished the display returns to the initial 021 setting
Use the ‘Cancel’ key to scroll back to ‘DOOR OPEN’ message to ensure new
settings are saved to the CPU.
LOAD/READ AUDIT – Address 22
1. Open door and operate door switch (power up)
2. Insert SIMM Card
3. Press the ‘Cancel’ button four times to enter “Service Mode”
4. Enter address 022 and press enter (Vend button)
5. Use Whipped/Extra White button to scroll up and down