Westomatic Eco Encore, Technical Manual

Page: 75 / 150

74
3. To replace the brewer ensure that the two arrows are aligned. Place hand
over brewer, hold so that it is back from the positioning holes and slide
forwards into position. Tighten thumbscrews (only need to be finger tight).
4. See details of the correct home position in Step 6 - Brewer Alignment
Step
6
–
Brewer Alignment
IMPORTANT NOTE
ENSURE ARROWS COMPLETELY ALIGNED BEFORE PROGRESSING ANY
FURTHER. BE READY TO TURN OFF THE MACHINE IF THE DOTS ARE
NOT ALINGED DURING THE VEND
See details below:
1. If the Dots on the brewer are not aligned, adjust the drive cam at the back of
the brewer mounting bracket, until the dots are aligned correctly and the
brewer ‘locks’ into the dispense position.
2. Check the home position of the brewer – the arrows should approximately
line up (+/- 5mm).
3. If the arrows on the brewer are not aligned within this tolerance, the homing
switch may need to be adjusted slightly, loosen the two fixing screws make
the necessary adjustment and tighten the two fixing screws.
4. Recycle the power to activate the home cycle.
5. Only continue once the positions for ‘dispense’ and ‘home’ are aligned.
6. Ensure that fresh beans are being used
ARROWS Aligned
DOTS Aligned (Exactly)
Drive lever
Dispensing Position
Home Position
Drive Motor with
Cam & Switches
CRG= Home
CPP= Dispense
Drive
Cam