WaxJet 6100, Service Reference Manual

Page: 51 / 131

VERIFY [Y/N]
•
All models except Series 8
This command will allow the user to verify that the controller did
receive the down loaded graphics. Used for verification only. At
the command prompt, the keystrokes are
V E
The display will show the font codes that have received logos. If
no logos had been received, the printer would display “00”
indicating that no downloaded logos were received by the printer.
ASCII String
To verify if a logo has been downloaded, enter:
VE<CR>
ZAP
•
All models
This command will reset all parameters and messages to factory
default settings. At the command prompt, the keystrokes are
Z A
Enter
Y
for Yes
.
Press R
Now turn the controller
OFF
then back
ON
, this will
complete the ZAp command.
•
Do not press any other keys or the ZAp will not take place.
ASCII String
To perform a ZAP using external programming, use the following
steps
Enter ZAY<CR>
Cease all communications to the FoxJet controller.
Cycle power off to the FoxJet controller, then back on.
Command Definitions 5-17