WaxJet 6100, Service Reference Manual

Page: 37 / 131

ID [1-99]
Identification for SystemMaster network operation. Defaults to
99 at power up and accessed only through the keyboard. To
change use keystrokes
I d
LEVEL [Y/N]
The CURVE command is disabled when LEVEL command is set
to N. Setting LEVEL to Y allows the CURVE command to be
executed. Adjusting CURVE would not normally be done using
external programming. Keystrokes are
l e
ASCII String
To enable access to the CURVE command, enter:
LEY<CR>
NETWORK [Y/N]
•
All models
Sets FoxJet printer system(s) to operate under SystemMaster
network and accept SystemMaster commands via the Rear Port
connection. Avoid input conflicts by returning display screen to
main menu. This command is set at installation via the
controller’s input terminal. Keystrokes are
n e
SLANT [0-31]
•
Models – All models except Series 9 & 8
This command adjusts the angle of the print to obtain a vertical
image when using nozzle arrays that are slanted (WaxJet, Series
7 printheads 192/32 and 96/32). Divide the print DPI (see WIDTH
command) by 18 to calculate the proper slant value for WaxJet
printheads. At the command prompt, the keystrokes are
S L
ASCII String
To change the SLANT to 7, enter:
SL7<CR>
Command Definitions 5-3