Driver PCB
Some components on PCB’s are static sensitive. It is recommended
that static discharge precautions be observed when working in and
around the FoxJet controller and when handling FoxJet printed
circuit boards.
Removal
1. Turn off system power.
2. Disconnect all cables from Driver PCB.
3. Remove board from standoff posts.
Installation
1. Place board on standoff posts and secure with screws.
2. With system power off, connect Printhead Data Cable to J1.
3. Discharge high voltage capacitance from power cable (pins 1 & 2)
and connect to J4.
4. Connect CPU Interface Data Cable to J3.
5. Apply system power. Monitor indicators for proper operation.
6. Print a test pattern after system has reached operating
temperature to ensure that all channels are printing properly.
7. Return to normal operation.
8-4
Removal/Replacement Procedures
Summary of Contents for 6100
