Operation & Maintenance Manual
──
LG936L Wheel Loader
81
Digging and Shoveling Material on Flat Ground
Lightly set the bucket edge leaning on the ground (see
picture) when digging and shoveling material on flat
ground. Be careful not to fasten the load to one side
which will cause unbalance. This operation should be
carried out carefully in gear .
Ⅰ
z
Lightly set the bucket edge facing down.
z
When driving the machine forward, operate the working
equipment control lever to let the lift arm lower down to
the proper position so that it can pick up a thin layer of the
surface each time when excavating the soil.
z
When driving the machine forward, shift the working
equipment control lever backward and forward slightly to
reduce the resistance.
△
!
NOTICE
Keep the two sides of the bucket cutting into the material equally
to prevent only a single side working. Face the loader forward and
never
let an angle exist between the front and rear frame.
(3)
Conveying Operation Without Truck
The loader must be used without a truck under the following conditions:
z
The ground is too soft and not level, and the truck can not be used.
z
When the transportation distance is within 500 meters, it is not economical to use a truck.
z
The transportation driving speed is determined by the road condition.
z
In order to get good visibility and stability, the bucket should be turned to its upper limit
location(bucket lift-arm touch the upper limited block) and keep the lower pin connection point
of lift-arm at the transportation position (400~500mm above the ground).
