Vollrath STL-80SS, Operator'S Manual

Page: 31 / 74

28
Sanitizing the Injector System
1. Prepare detergent water by mixing several
drops of Dawn
®
dish soap with a gallon of
warm water (108°F / 42°C). Prepare
sanitizer solution by mixing half a packet (1
oz) of Stera-Sheen® Green Label with one
gallon of warm water (108°F / 42°C). Pour
approximately 16 oz. of this sanitizer
solution into a spray bottle and set aside the
rest.
1. Submerge the Gear Box and nut in warm
water (108°F / 42°C) and soak for at least 5
minutes. Proceed with Steps 3 and 4 in the
meantime.
2. Brush and clean all exposed surfaces of the
Gear Cartridge with detergent water, and
then rinse thoroughly with warm water
(108°F / 42°C).
3. Brush and clean all exposed surfaces of the
Injector Head with detergent water, then
rinse thoroughly with warm water (108°F /
42°C). Use a small brush to ensure the
syrup orifices are completely clear.
4. When the Gear Box and nut have soaked
for at least 5 minutes, brush and clean all
exposed surfaces and openings with
detergent water and rinse thoroughly with
warm water (108°F / 42°C).
NOTE:
UNDER NORMAL OPERATING
CONDITIONS, IT IS NOT ADVISORY TO
BRUSH OTHER AREAS INSIDE THE GEAR
BOX. DOING SO MAY CAUSE DAMAGE.
NOTE: DO NOT OPEN OR DISASSEMBLE
THE GEAR BOX.
5. Remove the o-rings from the adapter body.
Brush and clean the parts with detergent
water. Then rinse thoroughly with warm
water (108°F / 42°C).
6. Submerge the Gear Box, nut, Gear
Cartridge, Injector Head, spout adapter, and
o-rings in the sanitizer solution and soak for
at least 5 minutes.