50
9. Place the anchor bracket within the arms of
the Touch Panel plate so that the flat end of
the anchor bracket extends away from the
front of the Touch Panel.
10. Insert the hex bolts through the Touch
Panel plate arms from the outside, through
the upright slots of the anchor bracket.
Secure the bolts with the lock nuts with the
washers between the nuts and the bracket.
11. After the base plate has had an hour to
cure, mount the Touch Panel and bracket
assembly to the base plate. Use the hand
knobs to attach the assembly to the posts of
the base plate and tighten them to secure.
12. To position the Touch Panel closer or
further from the freezer operator, loosen the
base plate hand knobs and slide the
assembly forward or backward. Ensure the
anchor bracket is secured to all four posts of
the base plate. Tighten the hand knobs to
secure the desired position.
NOTE:
IF THE BACK SLOTS OF THE
ANCHOR BRACKET ARE NOT SECURED
TO THE BASE PLATE, THE TOUCH
PANEL MAY PUT TOO MUCH WEIGHT
ON THE FRONT OF THE ASSEMBLY,
CAUSING THE ASSEMBLY TO BECOME
UNSTABLE OR LOOSEN FROM THE
FREEZER.
13. To adjust the height or angle of the Touch
Panel, loosen the hex bolts and lock nuts
and move the Touch Panel into the desired
position. Tighten the bolts to secure.
14. Thread the ethernet cable through the
mounting bracket and back behind the
freezer.
Summary of Contents for STL-80SS
