Vollrath STL-80SS, Operator'S Manual

Page: 56 / 74

53
Installing the Spout Adapter
Every STL-80SS system ships with an adapter
that attaches to the spout of the freezer. The
STOEADPT500FBA spout adapter fits most
Stoelting freezers. It has two o-rings. Always
keep extra o-rings in the Spare Parts Kit as they
are wear items.
Additional adapters are available from White
Glove Service for use with other Stoelting
models. See the ALTERNATE PARTS AND
KITS BY FREEZER MODEL section for more
information.
1. Ensure the freezer door spout is clean and
sanitized according to the freezer
manufacturer’s instructions.
2. Install the o-rings in their proper positions
on the adapter body.
3. Install the spout adapter assembly,
complete with o-rings, onto the freezer
spout. Push up on the adapter with your
palm until it snaps on. Ensure it is evenly
and fully installed.
Installing the Injector System and
Suspension Bracket
The suspension bracket helps stabilize the
Injector Assembly on the freezer. When
properly installed on the freezer, the bracket
should hold the Injector Assembly level
horizontally, with the Injector Head lined up
directly under the spout adapter. Two different
suspension brackets are included with this
system: one for freezer doors with four knobs /
posts, and one for freezer doors with two knobs
/ posts. Additional suspension bracket styles
may available for other freezer models through
White Glove Service.
The Injector Assembly can be mounted to either
side of the freezer spout. The 9-Tube Assembly
may also come from either side, regardless of
the Injector Assembly’s position. Images below
show installation on a 4-knob/post freezer with
multiple barrels.
RECOMMENDED POSITIONING:
(A) When possible, install the Injector
Assembly on the opposite side of the 9-
Tube Assembly’s placement.
Placing
the Drive Motor end of the assembly
opposite from the 9-Tube Assembly
makes it easier to attach and remove
the 9-Tube Assembly when cleaning.
(B) If there are vents on the side of the
freezer that blow out warm air, install the
9-Tube Assembly on the opposite side.
The air could warm the syrup and affect
the look of the soft serve product when
served. Installing the 9-Tube Assembly
on a side that does not have vents
blowing air will keep the syrup cool and
product consistent.