PAGE | 01
Installation Instructions
User Manual
Automatic Liquid Soap Dispenser
Model:
ASD-13
ASD-13
Soap Dispenser
Stainless Steel Construction
Dispenses Standard
Liquid Soap Only
,
commonly found in retail stores
1000ml Integral / Soap Bottle
Vandal Key
Integral Battery Compartment
Mounting Hardware
Batteries Pre-installed
(6 AA)
All hardware necessary for satisfactory installation
Package Includes
8
66 558 3200 310 919 3073 Info@mac
fauc
ets.com www.mac
faucets.com
M
AC FAUCETS
Calif
ornia, USA
D
E
S
IGNE
D
&
A
SS
E
M
B
L
E
D
IN TH
E U
S
A
3-11/116”
10-13/16”
4”
01
05
07
Please cut for drilling holes
Drill Holes Ø 1/4”
O
nce the location for the Soap
dispenser has been decided,
proceed with the installation
steps below, if the soap
dispenser is installed above the
sink, leave a space of 18” from
the top of the sink to the
bottom of the soap dispenser as
shown below in figure (A).
1. Cut the template from the
back of the dispenser box.
2. Use a level to align the
template correctly.
3. Use painters tape to hold the
template in place.
4. Drill holes for supplied plastic
anchors.
03
04
02
Place the plastic anchors in the holes. Drive
them in with a lite hammer.
Align the holes of
the dispenser with
the holes of the
anchors. Insert
screws in and
fasten using a
Phillips screw
driver.
Insert the key into the hole
located at the top of the
dispenser, push down with the
key and pull the cover open.
The cover engages a power
cut-off switch located in the
dispenser. The dispenser will
not activate when the cover is
in the open position.
Tools Needed
Safety Glasses
Drill bit
Ø 1/4” Carbide
Drill for tile
Cordless Drill
Hammer
Level
Phillips Screw Driver
Tape
06
18”
Fig. A
