43
IP DECT 6000 System Installation & Configuration Guide
A100K10652
8
Configuring the IP DECT Server 6000
This section provides you with information on how to power up the IP
DECT Server 6000 and connect the unit to a computer. It also contains
information on how to configure a Server 6000 through the web-based
user interface using either DHCP or a static IP address.
)
The IP DECT Server 6000 is pre-configured to use a static IP address.
This section includes information about:
●
“Powering up the Server 6000”
●
“Connecting a Computer to the Server 6000”
●
“Accessing the Server 6000”
● “Configuring the Server 6000 Using Static IP Address”
●
“Checking the LED Indicator”
8.1 Powering up the Server 6000
After installing the Server 6000 you need to power up the unit using a
local power supply.
Power options for the Server 6000 is 48VDC, 1 W maximum when using
local power supply.
8.1.1 Local Power Supply
Powering the Server 6000 with a local power supply can be done using
the power input on the unit.
)
The power supply for the IP DECT Server 6000 is ordered separately (Part no.
221 110 0225).
8.2 Connecting a Computer to the Server 6000
The Server 6000 communicates with the computer through a cross-over
patch cable.
)
The Ethernet port of the Server 6000 is an RJ45 connector.
To connect the Server 6000 to a computer:
1. Connect the cross-over patch cable to the computer.
2. Connect the cross-over patch cable to the Ethernet (ETH) port of the
Server 6000.
Figure 23 Faceplate showing Ethernet port
